Elbow Right command will draw a bend towards the right of selected open-ended duct, pipe or conduit, at the unconnected end closest to your mouse-click.


In Revit:

  • In the ribbon, navigate to the NAVIATE tab >> NAVIATE Fabrication panel >> Elbow Right.


  • Select an open-ended duct, pipe or conduit.  


The command will draw an elbow horizontally towards the right relative to the selected element, at the unconnected end closest to your mouse-click.


If the selected element is horizontal or has a slope within the tolerance of +/- 1/2" / 12" (+/- 4°), the slope will be inherited.