With the help of the Elbow Down command, the user is able to select an open-ended duct, pipe or conduit.  The command will draw a bend down at the unconnected end closest to your mouse-click. This command will work in 2D and 3D views.


In Revit:

  • In the ribbon, navigate to the NAVIATE tab >>NAVIATE  MEP panel >> Elbow Down command:


  • Select an open-ended duct, pipe or conduit.  


The command will draw an elbow down at the unconnected end closest to your mouse-click.


Notes:
  1. On horizontal and sloped MEP runs – Elbow Down will go straight down.

  1. On vertical connected MEP runs – Elbow Down will go down relative to the vertical MEP run in relation to the previous connected segment.

  1. On the top end of vertical unconnected MEP runs – Elbow Up will go South.
  2. On the bottom end of vertical unconnected MEP runs – Elbow Up will go North.