With the help of the Elbow commands, the user is able to select an open-ended duct, pipe or conduit. Depending on the sub-types of the command, the command will draw a bend at the unconnected end closest to your mouse-click. This command will work in 2D and 3D views.


In Revit:

  • In the ribbon, navigate to the BIMrx tab >> BIMrx Fabrication panel >> Elbow Commands.


  • Select an open-ended duct, pipe or conduit.  


The command will draw an elbow at the unconnected end closest to your mouse-click, the direction of the elbow is dependent on the sub-type of the command (e.g. Elbow Up, Elbow Down etc). If the closest connector is already connected or otherwise unavailable, the elbow will attempt to draw an elbow in another connector.