With the help of the Elbow Up command, the user is able to select an open-ended duct, pipe or conduit.  The command will draw a bend up at the unconnected end closest to your mouse-click. This command will work in 2D and 3D views.


In Revit:

  • In the ribbon, navigate to the BIMrx tab >> BIMrx MEP panel >> Elbow Up command.


  • Select an open-ended duct, pipe or conduit.  


The command will draw an elbow up at the unconnected end closest to your mouse-click.


Notes:
  1. On horizontal and sloped MEP runs - Elbow Up will go straight up.

  1. On vertical connected MEP runs - Elbow Up will go up relative to the vertical MEP run in relation to the previous connected segment.

 

  1. On the top end of vertical unconnected MEP runs – Elbow Up will go North.
  2. On the bottom end of vertical unconnected MEP runs – Elbow Up will go South.