With the help of the BIMrx Fabrication Settings feature, the user can now customize their ribbon panel locations. 


In Revit:

  • In the ribbon, navigate to the BIMrx tab >> BIMrx Fabrication panel >> Settings arrow feature:
    • The Settings arrow is in the bottom right-hand side of the ribbon


This opens up the following BIMrx Fabrications Settings dialog:


In the dialog, users can configure the following settings:

  • Bloom Duct and Cable Tray Length - the lengths of new Fabrication Duct and Cable Tray segments produced by Fabrication Bloom command
  • Bloom Pipe and Conduit Length - the lengths of new Fabrication Pipe and Conduit segments produced by Fabrication Bloom command
  • Elbow Duct and Cable Tray Extension Length - the lengths of new Fabrication Duct and Cable Tray segments produced by Fabrication Elbow commands
  • Elbow Pipe and Conduit Extension Length - the lengths of new Fabrication Pipe and Conduit segments produced by Fabrication Elbow commands


  • Click OK to accept the changes.