With the help of the BIMrx Fabrication - Align Branch command, the user is able to click on a main followed by a branch. This command will move the branch so it can logically intersect with the main when you use the trim or extend command. It will not change the slope or the angle of either pipe. This command will work in 2D and 3D views.


In Revit:

  • In the ribbon, navigate to the BIMrx tab >> BIMrx Fabrication panel >>  Align Branch command:


  • Click on a main followed by a branch. 


The command will move the branch so it can logically intersect with the main when you use the trim or extend command. It will not change the slope or the angle of either pipe.